Phase47 wrote:Every time I save and close a session with Etch in the project (Logic 9.1.7), whenever I re-open the session, Etch, instead of being on whichever preset (custom or not) the session was saved on, resets to it's Default patch/state. What gives?
Is this a known bug or does Etch somehow work differently than every other plugin I've got. What's the trick? Maybe I'm missing something obvious?
Paul_fx wrote:Are you using the demo?
Do the values update properly and just the name in the preset box says "default"? (which is what it does, I.e. the name only isn't being recalled but all the values update)
This is the only report we have had of this, so I'm guessing it's one of the above. If etch really wasn't saving in logic, we would have had a lot of reports...
Paul_fx wrote:Im planning on doing a new build in the next few days. Assuming that it gets through our internal QA process it should be out in the wild the near future. Again, no promises on dates / times, but it is being worked on atm
Users browsing this forum: No registered users and 1 guest
THANKS FOR SIGNING UP
WELCOME TO THE FXPANSION COMMUNITY!