Using TransMod modulation

The TransMod modulation system allows you to route a single modulation source to multiple synthesis and effect parameters, each with its own definable depth.

Modulation depths are represented visually on the parameter itself, rather than in an abstract list of assignments.

TransMod modulation occurs at control rates, in 32-sample blocks.




There are 2 types of 'views' of the synthesis parameters:

Initial Source view (Source)

To activate this view, click the Source button (this button is activated by default).

In this view, no modulation depths can be viewed or created. You simply set the initial value of any parameters before any modulation occurs.

TransMod modulation source views

To the right of the Source button are a number of buttons which represent the various TransMod modulation sources that are available.

Clicking any of these buttons means that you can view and create modulation depths from the TransMod source to Maul's parameters. Modulation depths can be seen and set visually on parameters, with indicators showing the current state of the control.

The modulation depth that is set represents the maximum amount of modulation possible from the TransMod source. The changing intensity of the TransMod source, and the combined effect of any other TransMod sources which have been routed to the parameter, dictate the actual modulation that occurs at any one time.

Only one TransMod source 'view' is visible at any one time.

In the following example, LFO1 is modulating the Drive parameter in the Mid drive stage.

The extent of the modulation depth shown represents the maximum amount of possible modulation away from the Source value - in this example, when the LFO has reached its maximum point.




With the Source button selected, no modulation is shown. Note the real-time indicator showing the current value of the Mid stage Drive control.

With the LFO1 TransMod source selected, the destination modulation amount is shown around the Mid stage Drive control.


Adjusting modulation depths

To adjust the modulation depth of a control:



First make sure that the desired TransMod source is selected.






Mouse over the outer ring of the control - notice the cursor has changed.

Click and drag up/down on the outer
edge of the control to set the modulation amount.


Controls that cannot be modulated

Most of Maul's parameters can be modulated, although there are some exceptions:

Phase control in LFOs

All buttons and switches


Real-time modulation indicators

Any modulation that occurs causes a control's actual value after modulation to be shown on controls in real time.